ORing Industrial Networking. Industrial Wireless Access Point Router.

Home │ Sitemap │ Contact Us

Industrial Ethernet Switch

µ-Ring Ethernet Switch

Unmanaged Ethernet Switch

Lite-managed Ethernet Switch

Managed Ethernet Switch

Giga Ethernet Switch

IP-67 Ethernet Switch

P.O.E Switch

PCI Ethernet Switch Card

Networking Management Utility

Industrial Device Server

Device Server

Secure Device Server

Wireless Device Server

Industrial Media Converter

100FX Media Converter

Industrial Wireless Solution

Wireless Access Point

Wireless Access Point Router

IAR-7002-WG

Industrial 802.11b/g Access Point Router

Datasheet

Highlights

	High Speed Air Connectivity: WLAN interface support up to 54Mbps link speed
	Provide HNAT enhance LAN to WAN routing performance
	Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X/ Radius supported
	USE interface support 3.5G HSDPA USB Modem dial up
	Support VPN for secured network connection
	Redundant Power Inputs: 12~48VDC on terminal block
	Fully Compliant with IEEE802.3af (Power Device at ETH2, IAR-7002-WG+)
	Secured Management by HTTPS and SSH
	Event Warning by Syslog, Email, SNMP Trap, Relay and Beeper

Features

	WLAN interface support up to 54Mbps link speed
	Various kind of encryption supported: WEP/WPA/WPA-PSK(TKIP,AES)/WPA2/ WPA2-PSK(TKIP,AES)/802.1X/ Radius
	Various kind of WAN Connection Type supported: Dynamic/Static IP,PPPoE,Modem/3G.
	Dual redundant Ethernet port support redundant mode (Recovery time < 10ms)
	Ethernet switch mode enable Daisy Chain
	Wireless connecting status monitoring
	Versatile modes & event alarm by e-mail
	IP table to prevent access from unauthorized IP address
	Support VPN Setting (Open VPN , PPTP VPN)
	Support NAT Setting(Virtual Server , Port Trigger , DMZ , UPnP)
	1KV isolation for PoE PD port of IAR-7002-WG+
	Dual redundant DC power inputs of terminal block
	Rigid IP-30 housing design
	DIN-Rail and panel mounting enabled

Introduction

IAR-7002-WG/WG+ is a reliable 802.11b/g WLAN Access Point with 2 ports 10/100TX ports where ETH1 for LAN ETH2 for WAN. It could be configured to operate in 3 modes of routing function: Dynamic/Static IP route, PPPoE authentication, and Modem (56K/GPRS/3G/3.5G Modem) dial up. In the mode of Modem dial up, it can not only support traditional 56K modem but also GPRSG/3G/3.5G Modem by USB interface. Users can set up WLAN environment to fulfil demands of various applications rapidly by dialing up cellular modems. In addition, IAR-7002-WG+ also provides PD feature on ETH2 which is fully compliant with IEEE802.3af P.O.E PD specification. This feature extends the layout up to 100 meters. Therefore, IAR-7002-WG/WG+ are one of the best solution for applications of wireless communication.

Home │ About Us │ News & Events │ Products │ Technologies │ Applications │ OEM │ Support │ Where to buy │ Contact Us