IAR-7002-WG/WG+ is a reliable 802.11b/g WLAN Access Point with 2 ports 10/100TX ports router where ETH1 for LAN ETH2 for WAN. It could be confi gured to operate in 3 modes of routing function: Dynamic/Static IP route, PPPoE authentication, and Modem (56K/GPRS/3G/3.5G Modem) dial up. In the mode of Modem dial up, it support both traditional 56K modem and GPRSG/3G/3.5G Modem with USB interface. Users can set up WLAN environment to fulfi ll demands of various applications rapidly by dialing up cellular modems. In addition, IAR-7002-WG+ also provides PD feature on ETH2 which is fully compliant with IEEE802.3af P.O.E PD specifi cation. This feature extends the layout up to 100 meters. Therefore, IAR-7002-WG/WG+ are one of the best solution for applications of wireless communication.
Product Features
•
WLAN interface support up to 54Mbps link speed
•
Various kind of encryption supported: WEP/WPA/WPAPSK(TKIP,AES)/WPA2/ WPA2-PSK(TKIP,AES)/Radius
•
Various kind of WAN Connection Type supported : Dynamic/Static IP, PPPoE, Modem/3G
•
Dual redundant Ethernet port support redundant mode (Recovery time < 10ms)
•
Ethernet switch mode enable Daisy Chain
•
Wireless connecting status monitoring
•
Versatile modes & event alarm by e-mail
•
IP table to prevent access from unauthorized IP address
•
Support VPN Setting (Open VPN , PPTP VPN)
•
Support NAT Setting (Virtual Server , Port Trigger , DMZ , UPnP)
•
1KV isolation for PoE PD port of IAR-7002-WG+
•
Dual redundant DC power inputs of terminal block
•
Rigid IP-30 housing design
•
DIN-Rail and panel mounting enabled
Product Features
IAR-7002-WG
IAR-7002-WG+
10/100Base-T(X) Ports in RJ45 Auto MDI/MDIX
2
P.O.E. PD port
Present at ETH2
Fully compliant with IEEE 802.3af Power
Device specifi cation
Over load & short circuit protection
Isolation Voltage: 1000 VDC min.
Isolation Resistance : 108 ohms min
USB Host port
1x USB 2.0 Host port
WLAN interface
WAN Connection Type
Static/Dynamic IP / PPPoE / Modem (56K/GPRSG/3G/3.5G Modem) dial up
Introduction 
